Search Top Index
HELP V200 A. Sloman Dec. 1982 For an introduction to using the VISUAL 200 terminal see TEACH TEACH TEACH VED TEACH MOREVED TEACH VEDPOP THE FUNCTION KEYS AND KEYPAD KEYS ON A VISUAL 200 TERMINAL The function keys are on the top row. The keypad keys are on the right. -- FUNCTION KEYS ON TOP ROW: -------------------------------------------- F0 = DELETE CHARACTER UNDER CURSOR F1 = DELETE LINE TO LEFT OF CURSOR F2 = DELETE WHOLE OF CURRENT LINE F3 = DELETE LINE TO RIGHT OF CURSOR (including character under cursor) F4 = DELETE WORD TO LEFT OF CURSOR F5 = DELETE WORD TO RIGHT OF CURSOR F6 = SWITCH 'STATIC' MODE ON OR OFF F7 = MARK CURRENT LINE AS BEGINNING OF RANGE F8 = MARK CURRENT LINE AS END OF RANGE F9 = MOVE MARKED RANGE TO AFTER CURRENT LINE F10 = PUSH CURRENT POSITION ONTO POSITION STACK F11 = POP CURRENT POSITION FROM STACK F12 = INSERT LINE ABOVE CURRENT LINE F13 = INSERT LINE BELOW CURRENT LINE --REMAINING KEYS ON TOP ROW: ------------------------------------------------ Where the key is 'split' in the diagram below, the upper function is obtained by holding the 'CONVERT' button down while the key is pressed. E.g. CONVERT and PRINT causes the screen to be refreshed. _____________________________________________ | | | | PRINT | TOP OF | | SCREEN | TEXT | SCREEN |________|__FILE__| | LEFT | RIGHT | UP | SCREEN | END OF | |________|________|________|__DOWN__|__FILE__| The SCREEN LEFT button moves the cursor to the left of the SCREEN, but the TEXT RIGHT button moves to the right of the TEXT, on the current line. --KEYPAD KEYS --------------------------------------------------------- The'move' buttons (with asterisk) provide bigger moves if the CONVERT button is held down at the same time. ____________________________ | 7 *| 8 *| 9 *| | UP | UP | UP | | LEFT | | RIGHT | |________|________|________| | 4 *| 5 *| 6 *| | LEFT | CENTRE | RIGHT | | | | | |________|________|________| | 1 *| 2 *| 3 *| | DOWN | DOWN | DOWN | | LEFT | | RIGHT | |________|________|________| | 0 | , *| . *| | CHANGE | WORD | WORD | | MODE | LEFT | RIGHT | |________|________|________| | - | | | REPEAT | ENTER | | COMMAND | COMMAND | | (REDO) | LINE | |_____________|____________| The CHANGE MODE key moves the cursor up to the command line without altering the existing command. The REPEAT COMMAND (REDO) key causes the command on the command line to be obeyed. (You can also do this with CTRL _ (i.e. hold down CTRL and press the button with the underscore. This is also the DEL button on the Visual 200). The ENTER key causes the command line to be cleared, and the cursor left on the command line. See HELP *VEDKEYS for information about control characters and ESC sequences.